300 Blackout 153 Grain Powder Coated Cast Lead 1600 fps for .10 cents a round
I finally after some problems (look at my bullet sizing die problem video) have my supersonic 300 Blackout round working the way I wanted it. I use a NOE mould # HTC309-153-SP. This mould is a pleasure to use (I have a video of my casting these boolits).
Powder cost .04, Bullet Cost .03, Primer .03 = Total cost per round .10
I can enjoy shooting my 300 Blackout for just a little more than people are paying for 22 rounds now a days.
Of course I had to get some brass (223 is cheep and free if you go to a range and just pick it up) and I had a one time expense of the equipment to trim it down but it does not take long to make up that initial investment when you spend .10 a round instead of .50 to 1.00 a round. I am using Hodgdon H-110 powder. I do not wish to give my load because this bullet was not listed so I had to use data for the 150 grain different design and I had to reduce my charge a little.
What bolt gun do you have and or recommend? I have 300 in an AR but would like to have in bolt action.