3D Printed 320 PDW Frame testing

This is version 11 of this design, the 3rd version to be live fire tested. Really thought that this one might it"¦ it didn't.


Cycling without the suppressor was good, but the frame did crack at the takedown pin early in the testing and it broke at that point after almost 100 rounds.

On to Version 12.

The objective is to have a frame designer hat can be printed in a single piece to accommodate a fire control unit from a Sig P320 Pistol, a stabilizing brace and a laser/light.

Gunmakersmatch.com

#gunmaking #3Dprinting #robpincus #320pdw

Get more thoughts and information at www.facebook.com/robpincuspro