AR 15 Project Lower Parts and Tools

871 Views

In General

This is my first ever AR project and these are the parts and Tools I'm using for my lower reciever build.

Gun Streamer
https://gunstreamer.com/@Roostedfilms

Gun Channels
https://gunchannels.com/Roostedfilms1

Instagram
https://www.instagram.com/roostedfilms

Twitter
https://twitter.com/Roosted_films

3 Comments

Budget_Gun_Cinema 6 years ago

Howdy friend! Finally made my way over here lol! Subscribing to all my YT pals!

1 0

Roosted Remains 6 years ago

Hey brother great to see you over here

1 0

NC Gun Guy 6 years ago

Building ARs are addictive, once you do one it is hard to stop. I use taped up channel locks on the roll pins to squeeze them in instead of tapping them in with the punches. No matter how well I tape up the lower I always scratch it. Be very mindful of the detent and spring when installing the front takedown pin. It’s very easy to launch them into never - never land. My first one I did inside a big clear plastic bag as a friend suggested so I wouldn’t loose the detent. Good thing to because I launched it a couple times before for I got it in. Good luck.

1 0

Roosted Remains 6 years ago

I'm going to buy a 1/4 clevis pin for that install next time. I launched the spring and detent TWICE! It went together relatively smooth update coming soon. Thanks NC

1 0

NC Gun Guy 6 years ago

Glad to here

1 0

TheRealCobraBurnout 6 years ago

That punch kit looks good. Big respect for getting/using Aeroshell!

1 0

Roosted Remains 6 years ago

Thanks Cobra. The Areoshell was cheap enough and that little container will do prob 100 rifles . Much more than I need. If your going to do it DO IT RIGHT!

0 0

TheRealCobraBurnout 6 years ago

@Roosted Films: Yes Sir. I grabbed a full tube a while back. I'll never use it all. lol.

1 0

Up next

Autoplay