Sig P365 Issues

633 Views

In General

Sig P365 issues
Sig P365 does not like Remington 115gr. *Beware.
I've had 0 issues with Winchester 115 or 124, I've had 2 issues with Federal 115. The gun itself is fine, so is the striker, I'm at 1900 rounds thus far.

Sig p365 Failure to eject

1 Comments

RobertM 5 years ago

Yep. Yours does not like Remington for whatever reason. I just shoot Federal in my 365 with all kinds of different Federal ammo and no problems at all. Its been flawless. HP, FMJ ball, Frangible HP, brass and aluminum cased. I have 481 rounds on it now. Of all that ammo and no failures I put 300 rounds of aluminum cased through it for the real test. Have not used other brands. Thanks for sharing that.

1 0

Gun Guy2a 5 years ago

Yes some guns are ammo sensitive. My g43x ate up all the remington. I put some 124gr through the p365 and no issues so its for sure ammo related. Good luck with yours & thanks for the feedback!

1 0

RobertM 5 years ago

@Gunguy2a: I would be willing to bet that extraction problem could be solved with a different designed extractor. Had the same problem with my Savage Axis bolt. Some case rims it would not grab. So I got an aftermarket extractor kit with a slightly smaller extractor and stronger ejector. Problem solved. It will eject any thing now.

1 0

RobertM 5 years ago

@Gunguy2a: To be on the safe side and I need to do the same to mine, it would be a good idea to take down and clean your extractor and extractor spring. Never know. Might be some grease or crud in there. Better safe than sorry.

1 0

RobertM 5 years ago

@RobertM: I know its going to be a pain in the neck to tap out that roll pin and then put it all back together after cleaning and get the pin tapped back in.

0 0

Up next

Autoplay