MosinVirus 24 Apr 2018

1911 Build 2 - MosinVirus

5 / 15

1

1911 Build 2 (9mm) - Part 1 - Frame to Slide Fit

2

1911 Build 2 (9mm) - Part 2 - Fitting a Bull Barrel to Slide

3

1911 Build 2 (9mm) - Part 3 - Chamber Reaming

4

1911 Build 2 (9mm) - Part 4 - Barrel to Slide Stop Fit

1911 Build 2 (9mm) - Part 5 - Feed Ramp/throat Work

6

1911 Build 2 (9mm) - Part 6 - Novak Sight Cuts By Hand

7

1911 Build 2 (9mm) - Part 7 - Hammer and Sear Pin Holes

8

1911 Build 2 (9mm) - Part 8 - Firing Pin Stop Fitting

9

1911 Build 2 (9mm) - Part 9 - Thumb Safety Fitting

10

1911 Build 2 (9mm) - Part 10 - Slide Serrations Cutting

11

1911 Build 2 (9mm) - Part 11 - Slide Porting/Lightening

12

1911 Build 2 (9mm) - Part 12 - Beavertail Safety Fitting and Blending

13

1911 Build 2 (9mm) - Part 13 - Blending Continued

14

1911 Build 2 (9mm) - Part 14 - Test Fire, Fix, Repeat

15

1911 Build 2 (9mm) - Part 15 - Anodizing the Frame

1911 Build 2 (9mm) - Part 5 - Feed Ramp/throat Work

0

0

3089 Views

In General

Since 9mm standard barrels will overhang the .45acp frame feed ramps, the barrel face needs to be reduced on the bottom and a throat needs to move forward. However, make sure to not reduce the case support to unsafe limits when doing this.

Show more

0 Comments