How To Install The Apex Action Enhancement Trigger For The Springfield XDs Mod.2

2011 Views

In General

Apex's Scott Folk walks you through the proper way to install the Apex Action Enhancement Trigger for the XDs Mod.2 pistol from Springfield Armory.

To Order: https://bit.ly/ApexXDsTrigger

Recommended Tools:
– 1/16" Pin Punch
– 3/32" Pin Punch
– 3/32" Roll Pin Punch
– Small 6oz to 8oz Hammer
– Smooth Jaw Vise
– A Roll of Tape (handy but not required)

Timecodes
0:00 - Intro
0:37 - Tools
0:51 - Kit Contents
0:58 - Installation Caution
1:09 - Removing Pins
1:37 - Remove Internals
1:55 - Remove Trigger Bar from Sear Housing
2:09 - Sear Housing & Grip Safety Spring Orientation ID
2:48 - Replacing Grip Safety Spring
3:21 - Remove Factory Trigger from Trigger Bar
3:34 - Apex vs Factory Components ID
3:48 - Installing the Apex Trigger on the Factory Trigger Bar (use a vise)
5:23 - Function Check Trigger Body & trigger Bar
6:04 - Reinstall Trigger Bar Into Sear Housing
7:42 - Reinstall Trigger Bar & Sear Housing Into Frame
8:21 - Installing Sear Housing Pin
8:55 - Reinstall Magazine Safety Plate
9:14 - Reassemble Locking Block
9:42 - Reinstall Slide Lock Lever & Locking Block
11:24 - Install Remaining Pins
12:45 - Function Check of Assembled Frame
13:34 - Final Function Check

————————
SOCIAL LINKS
————————
FULL30: https://www.full30.com/channels/apext...
INSTAGRAM: https://www.instagram.com/apextactical
FACEBOOK: https://www.facebook.com/apextactical
TWITTER: https://twitter.com/apextactical
GUNSTREAMER: https://gunstreamer.com/@ApexTactical

Customer Service Inquiries: [email protected]
© Apex Tactical Specialties

0 Comments